iPhone guide

iPhone No Service: diagnosis order for technicians in Pakistan

Technician checklist for No Service or Searching: PTA status first, SIM and carrier checks, IMEI and modem firmware, then SIM reader, antennas and the baseband.

By the iFixApplePhone repair team, Faisalabad ·

یہ گائیڈ اردو میں پڑھیں

Quick answer

In Pakistan, start a No Service job with PTA status, not with the soldering station. Order: PTA / IMEI → SIM and carrier → iOS settings → IMEI and modem firmware on the phone → SIM reader and antennas → baseband on the board. The two quickest hardware signs are a missing IMEI when you dial *#06# and an empty Modem Firmware line in Settings. Both point to the baseband side of the board, not the SIM or the antenna.

1. Intake

  • Did it ever work in Pakistan with this SIM? A phone that never worked is usually PTA or carrier lock (JV). A phone that stopped suddenly is SIM, settings, damage or a recent repair.
  • Was it dropped, wet, or repaired (screen, back glass, charging port)? Antenna contacts sit near those parts on many models.
  • Is it JV (carrier-locked with a patch or chip)? Ask directly: the patch is part of how it gets network.
  • Does it show No Service with every SIM, or only with one network?

2. PTA and IMEI first

  1. Dial *#06# and note the IMEI(s). Our IMEI checker checks the number is valid.
  2. Check the status by SMS to 8484 or on dvs.pta.gov.pk (steps in Check PTA status).
  3. A non-registered phone loses Pakistani network after the grace period. That is not a fault you can repair; the owner has to register it and pay the tax.
  4. Compare the IMEI on screen with the one on the SIM tray or box. A mismatch is a red flag: don’t work on the phone until the owner explains it.

3. SIM, carrier and iOS (Apple’s checks)

  • Try a known-good SIM from another network, and the customer’s SIM in another phone.
  • Turn Airplane Mode on and off, then restart.
  • Settings > General > About: if a carrier settings update is offered, install it (over Wi-Fi).
  • Dual SIM / eSIM: in Settings > Mobile Data (Cellular), check the line is turned on.
  • Remove and reinsert the physical SIM. A damaged SIM is replaced by the network.
  • Only the network can see whether the account is active or the line is barred.
  • Last software step: Reset Network Settings (removes saved Wi-Fi, VPN and APN settings).

4. JV and carrier lock

Settings > General > About > Carrier Lock should say “No SIM restrictions”. Anything else means the phone is locked to a carrier, and it works on a Pakistani SIM only through a workaround. If such a phone shows No Service, the patch or chip can be the cause (after an iOS update, a new SIM, or when the patch moves). Explain this before any repair. Background: What is a JV iPhone?

5. On-phone hardware signs

What you see Likely area
*#06# shows no IMEI, or IMEI is blank in Settings > General > About Baseband side of the board
Modem Firmware line in Settings > General > About is empty Baseband side of the board
IMEI and modem firmware fine, “No SIM” with every SIM SIM tray, SIM reader (connector or its flex), or its lines on the board
IMEI fine, SIM detected, weak or no signal, worse in one position Antenna flex or contacts, often after a back glass or screen repair
Searching / No Service only after a drop, intermittent when the phone is pressed Cracked solder joints on the board (baseband area)

6. Hardware: cheap to expensive

  1. SIM tray and reader: check the tray is the right model and not bent. Inspect the reader pins under the microscope.
  2. Antennas: check every antenna flex and screw contact you disturbed in the last repair. A missing or wrong screw, or a torn antenna flex, is a common cause after a back-glass job.
  3. Water: look for corrosion around the SIM reader and the antenna contacts.
  4. Board: missing IMEI or empty modem firmware is board-level work on the baseband section (power supply measurements, then the model’s schematic and boardview). Don’t promise a result before you have measured.

7. After the repair

  • Test calls in and out, mobile data, and both SIM lines (and eSIM if the phone has one).
  • Check signal in different positions and with the phone held normally.
  • If the phone is non-PTA or JV, write that on the job card next to the repair.

Not affiliated with Apple

iFixApplePhone is an independent repair shop in Faisalabad, not an Apple Authorized Service Provider. Bench steps are our shop’s method; Apple’s statements are linked below.

Sources: Apple, If you see SOS, No Service, or Searching on your iPhone and If your call fails or you can’t receive calls on your iPhone.

All repair guides

iFixApplePhone repair lab in Katchery Bazar, Faisalabad
Visit the lab · Katchery Bazar

Walk in, or message us first.

Saturday to Thursday · closed Friday10 AM - 10 PM
Phone & WhatsApp0304-6069068

Repaired with us? Leave a Google review