Mobile repairing tools list: starter kit to board level
The tools a mobile repair bench needs: screwdrivers, opening tools, testing, soldering, microscope, cleaning, programmers and safety. A starter kit and what to add later.
By the iFixApplePhone repair team, Faisalabad ·
Quick answer
A starter kit for screen, battery and charging port work is: a precision screwdriver set with the right bits, plastic opening tools and picks, a suction cup, a way to soften adhesive (heat plate or hot air), ESD-safe tweezers, a magnetic screw mat, a multimeter, a DC power supply that shows current, and a USB charging tester. For board-level repair add a soldering station, hot air rework station, a stereo microscope, flux, solder and reballing stencils. Never skip ESD protection and battery safety.
1. Opening and disassembly
- Precision screwdriver set with the bits phones actually use: pentalobe (iPhone bottom screws), tri-point (inside many iPhones), small Phillips and Torx. Worn bits strip screws, so replace them.
- Plastic opening tools, spudgers and thin picks: metal pry tools scratch frames and can puncture batteries.
- Suction cup to lift the screen.
- Heat plate, screen separator or hot air to soften adhesive on screens and back glass.
- ESD-safe tweezers (straight and curved) for connectors and small parts.
- Magnetic screw mat or a marked tray: iPhone screws differ in length, and a long screw in the wrong hole can damage the board.
2. Testing and diagnosis
- Multimeter for continuity, voltage and diode mode readings.
- DC power supply with a current display: power the board without a battery and watch the current to find shorts and boot problems.
- USB tester between charger and phone: shows voltage and current, so you can tell a bad cable or port from a battery or board fault.
- Known-good test parts (screen, battery, charging flex) to swap in and isolate a fault quickly.
3. Soldering and board level
- Temperature-controlled soldering station with fine tips.
- Hot air rework station for chips, connectors and shields.
- Stereo microscope: board work is not possible by eye.
- Flux, solder wire and paste, solder wick and reballing stencils for chips.
- Preheater for large boards and heat-resistant tape to protect nearby parts.
4. Cleaning and liquid damage
- High-purity isopropyl alcohol and soft brushes to remove corrosion and flux.
- Ultrasonic cleaner for liquid-damaged boards (remove the battery, screen and cameras first).
- Lint-free cloths and a dust blower for screens and camera lenses.
5. Programmers (iPhone)
Programmers read data from the original part and write it to the replacement, for example True Tone data on screens or battery data. They help a replacement part work more like the original, but they do not make a part genuine: iPhone’s Parts and Service History can still show it as Unknown. Tell the customer which part went in. See Is my iPhone screen original?.
6. Safety
- ESD mat and wrist strap: static damages chips without visible signs.
- Fume extractor for soldering and flux fumes.
- Fire-safe container (metal box with sand) for swollen or punctured batteries. Never pierce or bend a battery.
- Eye protection when removing glass and batteries.
- Good light and a stable, clean bench.
Starter kit or full bench?
| Stage | Add |
|---|---|
| Screens, batteries, ports | Screwdrivers, opening tools, suction cup, heat, tweezers, screw mat, USB tester |
| Diagnosis | Multimeter, DC power supply with current, known-good test parts |
| Board level | Soldering and hot air stations, microscope, flux, stencils, preheater, ultrasonic cleaner |
Run the counter too
Record every job with a job card and the IMEI, and every phone you buy with the seller’s CNIC. Our free mobile shop software does this in the browser: repair receipt, purchase receipt and bulk IMEI checker.

